3Com 3CRUS2475 - 8 Defining WLAN

156 CHAPTER 10: CLOCK COMMANDS
Example
The following example authenticates key 8.
sntp client poll
timer
The sntp client poll timer Global Configuration mode command sets
the polling time for the Simple Network Time Protocol (SNTP) client. To
restoreTo restoreTo restore default configuration, use the no form of this
command.
Syntax
sntp client poll timer seconds
no sntp client poll timer
Parameters
■ seconds — Polling interval in seconds. (Range: 60-86400)
Default Configuration
Polling interval is 1024 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the polling time for the SNTP client to 120
seconds.
Console(config)# sntp authentication-key 8 md5 ClkKey
Console(config)#
sntp trusted-key 8
Console(config)# sntp client poll timer 120