3Com 3CRUS2475 - Exec-Timeout

exec-timeout 101
User Guidelines
This command is available only on the line console.
To start communication using Autobaud , press <Enter> twice. This
configuration applies only to the current session.
Example
The following example enables autobaud.l
exec-timeout The exec-timeout Line Configuration mode command sets the interval
that the system waits until user input is detected. To restore the default
configuration, use the no form of this command.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
Parameters
■ minutes — Specifies the number of minutes for the timeout. (Range:
0-65535)
■ seconds — Specifies additional time intervals in seconds. (Range:
0-59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.
Console(config)# line console
Console(config-line)# autobaud