3Com 3CRUS2475 - Defining Router Groups

spanning-tree port-priority 215
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The path cost method is configured using the spanning-tree pathcost
method Global Configuration mode command.
Example
The following example configures the spanning-tree cost on Ethernet
port g15 to 35000.
spanning-tree
port-priority
The spanning-tree port-priority Interface Configuration mode
command configures port priority. To restore the default configuration,
use the no form of this command.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
Parameters
■ priority — The priority of the port. (Range: 0-240 in multiples of 16)
Default Configuration
The default port priority for IEEE Spanning TreeProtocol (STP) is 128.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Gigabit Ethernet (1000
Mbps)
20,000 4
Fast Ethernet (100 Mbps) 200,000 19
Ethernet (10 Mbps) 2,000,000 100
Console(config)# interface ethernet g15
Console(config-if)# spanning-tree cost 35000