3Com 3CRUS2475 - Beacon Period

500 CHAPTER 35: WIRELESS AP RADIO COMMANDS
Example
The following example configures antenna 1 for the transceiver.
beacon period The beacon period AP Interface Radio Configuration mode command
configures the beacon period. To restore defaults, use the no form of this
command.
Syntax
beacon period milliseconds
no beacon period
Parameters
■ milliseconds — Specifies the beacon time in milliseconds. (Range: 50 -
300)
Default Configuration
The default beacon period is 100 milliseconds.
Command Mode
AP Interface Radio Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the beacon period to 300 milliseconds.
Console (Config-wlan-ap)# interface radio 802.11g
Console (Config-wlan-ap-radio)# antenna 1
Console (Config-wlan-ap)# interface radio 802.11g
Console (Config-wlan-ap-radio)# beacon period 300