3Com SuperStack II - Page 104

104 C
HAPTER
4: W
ORKING
W
ITH THE
C
OMMAND
L
INE
I
NTERFACE
snmp get
Performs an SNMP GET command, that allows
you to retrieve values of SNMP objects from the
stack.
snmp next
Performs an SNMP GETNEXT command, that
allows you to specify an SNMP object and then
retrieve the next few SNMP objects from the
stack.
snmp set
Performs an SNMP SET command, that allows
you to modify the value of an SNMP object in
the stack.
snmp trap define
Specifies the trap destination details for the
stack.
snmp trap display
Displays the details of the current trap
destinations for the stack.
snmp trap modify
Modifies trap destination details for the stack.
snmp trap remove
Removes trap destination details from the stack.
system display
Displays administration details for the current
Switch unit in the stack.
system information
Specifies administration details for the stack.
system initialize
Initializes the Switch units in the stack.
system inventory
Displays a list of the Switch units in the stack.
system module define
Sets the IP configuration for a Switch Layer 3 or
Switch ATM module.
system module display
Displays the module configuration details.
system module mode
Allows you to enable or disable an intelligent
module.
system password
Specifies the password for the current user.
system remoteAccess
Enables and disables all forms of remote access
to the stack.
system reset
Resets the Switch units in the stack.
system security access
display
Displays the access rights for all access levels in
the stack.
system security access
modify
Modifies the access rights for the access levels
in the stack.
system security user
define
Specifies the user details for the stack.
system security user
display
Displays the user details for the stack.
Tab le 8
Command line interface commands
Command What does it do?