3Com SuperStack II - Page 106

106 C
HAPTER
4: W
ORKING
W
ITH THE
C
OMMAND
L
INE
I
NTERFACE
To display the statistical information:
1
At the Top-level menu, enter:
bridge display
2
The bridge information for the Switch is displayed as shown in the
following example.
The following bridge information is displayed:
■
StpState
— Displays the configurable parameter that provides the
state of the bridge (that is, whether Spanning Tree is enabled or
disabled).
■
Time Since Last Topology Change
— Displays the time elapsed (in
hours, minutes, and seconds) since STP last reconfigured the network
topology.
■
Topology Changes
— Displays the number of times that STP has
reconfigured the network topology.
■
Bridge Identifier
— Displays the bridge identification. It includes
the bridge priority value and the MAC address of the lowest
numbered port.
■
agingTime
— Displays the time-out period in seconds for aging out
dynamically learned forwarding information.
■
Designated Root
— Displays the root bridge identification. It includes
the root bridge's priority value and the MAC address of the lowest
numbered port on that bridge.
■
bridgeMaxAge
— Displays the maximum age value, used when this
bridge is the root bridge. This value determines when the stored
configuration message information is too old and is discarded.
stpState: disabled agingTime: 1800
Time since topology change: 0 hrs 0 mins 0 seconds
Topology Changes: 0
Bridge Identifier: 8000 08004e56d778
Designated Root: 0001 000000020000
maxAge: 0 bridgeMaxAge: 20
helloTime: 1 bridgeHelloTime: 2
forwardDelay: 105 bridgeFwdDelay: 15
holdTime: 1 rootCost: 131072
rootPort: No Port priority: 0x8000
Select menu option: