Refitting the hall sensor
Use these procedures to refit the hall sensor.
Refitting the axis-3 hall sensor
NoteAction
Hall sensor with attachment for axis 3:
3HAC052448-001
Refit the hall sensor with the screw and
washer.
1
Screws: 3HAB3409-241 (1 pc).
Tightening torque: 0.8 Nm.
xx1500000513
xx1500000512
Connect the hall sensor connector P3.
Put back the HSIB in place.
2
Screws: 3HAB3409-233 (2 pcs).Refit the cable bracket.3
Tightening torque: 0.8 Nm.
xx1500000559
Continues on next page
Product manual - IRB 14000 259
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
4 Repair
4.5.4 Replacing the axis-3 hall sensor
Continued
To Next Page
Loading...
