Name Values (Range) Unit Step Default Description
PulseMode6 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for
output 6
tPulse6 0.01 - 6000.00 s 0.01 0.10 Pulse time output 6
PulseMode7 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for
output 7
tPulse7 0.01 - 6000.00 s 0.01 0.10 Pulse time output 7
PulseMode8 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for
output 8
tPulse8 0.01 - 6000.00 s 0.01 0.10 Pulse time output 8
12.8.6 Operation principle
SEMOD176471-4 v7
The PSTO input selects the operator place (LOCAL, REMOTE or ALL). One of
the eight outputs is activated based on the command sent from the operator place
selected. The settings Latchedx and tPulsex (where x is the respective output) will
determine if the signal will be pulsed (and how long the pulse is) or latched
(steady). BLOCK will block the operation of the function – in case a command is
sent, no output will be activated.
PSTO is the universal operator place selector for all control
functions. Although, PSTO can be configured to use LOCAL or
ALL operator places, only REMOTE operator place is used in
SPC8GAPC function.
12.9 AutomationBits, command function for DNP3.0
AUTOBITS
SEMOD158589-1 v3
12.9.1 Identification
GUID-C3BB63F5-F0E7-4B00-AF0F-917ECF87B016 v4
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
AutomationBits, command function for
DNP3
AUTOBITS - -
12.9.2 Functionality
SEMOD158591-5 v8
Automation bits function for DNP3 (AUTOBITS) is used within PCM600 to get
into the configuration of the commands coming through the DNP3 protocol. The
Section 12 1MRK 505 394-UEN A
Control
394 Line differential protection RED650 2.2 IEC
Technical manual
To Next Page
Loading...
