ABB RED650 - DNP3 Protocol; IEC 61850-8-1 Communication Protocol; Functionality

IEC15000400-1-en.vsd
IEC15000400 V1 EN-US
Figure 316: Protocol diagnostic screen in LHMI
18.3 DNP3 protocol
GUID-54A54716-23BD-4E7C-8245-DE2B4C75E8DC v1
DNP3 (Distributed Network Protocol) is a set of communications protocols used to
communicate data between components in process automation systems. For a
detailed description of the DNP3 protocol, see the DNP3 Communication protocol
manual.
18.4 IEC 61850-8-1 communication protocol
IP14616-1 v2
18.4.1 Functionality
M14787-3 v15
IEC 61850 Ed.1 or Ed.2 can be chosen by a setting in PCM600. The IED is
equipped with four optical Ethernet rear ports for IEC 61850-8-1 station bus
communication. The IEC 61850-8-1 communication is also possible from the
electrical Ethernet front port. IEC 61850-8-1 protocol allows intelligent electrical
devices (IEDs) from different vendors to exchange information and simplifies
system engineering. IED-to-IED communication using GOOSE and client-server
communication over MMS are supported. Disturbance recording file
(COMTRADE) uploading can be done over MMS or FTP.
Section 18 1MRK 505 394-UEN A
Station communication
640 Line differential protection RED650 2.2 IEC
Technical manual