ABB RED650 - Settings; Function Commands Generic for IEC 60870-5-103; I103 Gencmd; Functionality

18.8.12.5 Settings
PID-3790-SETTINGS v5
Table 524: I103USRCMD Non group settings (basic)
Name
Values (Range) Unit Step Default Description
FunctionType 1 - 255 - 1 1 Function type (1-255)
PulseMode Steady
Pulsed
- - Pulsed Pulse mode
PulseLength 0.200 - 60.000 s 0.001 0.400 Pulse length
InfNo_1 1 - 255 - 1 1 Information number for output 1 (1-255)
InfNo_2 1 - 255 - 1 2 Information number for output 2 (1-255)
InfNo_3 1 - 255 - 1 3 Information number for output 3 (1-255)
InfNo_4 1 - 255 - 1 4 Information number for output 4 (1-255)
InfNo_5 1 - 255 - 1 5 Information number for output 5 (1-255)
InfNo_6 1 - 255 - 1 6 Information number for output 6 (1-255)
InfNo_7 1 - 255 - 1 7 Information number for output 7 (1-255)
InfNo_8 1 - 255 - 1 8 Information number for output 8 (1-255)
18.8.13 Function commands generic for IEC 60870-5-103
I103GENCMD
18.8.13.1 Functionality
GUID-729E9AFD-0468-4BBD-B54A-A6CDCC68A9B2 v3
I103GENCMD is used for transmitting generic commands over IEC 60870-5-103.
The function has two outputs signals CMD_OFF and CMD_ON that can be used to
implement double-point command schemes.
The I103GENCMD component can be configured as either 2 pulsed ON/OFF or 2
steady ON/OFF outputs. The ON output is pulsed with a command with value 2,
while the OFF output is pulsed with a command value 1. If in steady mode is ON
asserted and OFF deasserted with command 2 and vice versa with command 1.
Steady mode is selected by setting PulseLength=0. The I103GENCMD is retained,
and a command in steady mode will be reissued on restart.
18.8.13.2 Identification
GUID-1933A30C-5214-4116-8CD3-91BD975FACED v1
Function description
Function block
name
IEC 60617
identification
ANSI/IEEE C37.2
device number
Function commands generic for IEC
60870-5-103
I103GENCMD - -
Section 18 1MRK 505 394-UEN A
Station communication
724 Line differential protection RED650 2.2 IEC
Technical manual