Data Value Data Valid Comm Valid Test
Incoming data with q=test+oldData 0 0 1 1
Receiver in block 0 0 1 0
Receiver in block and
communication error
0 0 0 0
Receiver in test mode and incoming
data with q= Normal
Updated 1 1 0
Receiver in test mode and incoming
data with q= Test
Updated 1 1 1
Communication Error 0 0 0 0
At least one of the inputs of this GOOSE block must be linked
either in SMT by means of a cross or in ACT by means of a
GOOSE connection (if easy GOOSE engineering is enabled) to
receive any data. Only those outputs whose source input is linked/
connected will be updated.
The implementation for IEC 61850 quality data handling is
restricted to a simple level. If quality data validity is GOOD then
the DVALIDx output will be HIGH. If quality data validity is
INVALID, QUESTIONABLE, OVERFLOW, FAILURE or OLD
DATA then the DVALIDx output will be LOW.
18.4.13 GOOSE function block to receive a switching device
GOOSEXLNRCV
18.4.13.1 Identification
GUID-4B23D0CF-F298-4BBC-B833-1B8CC98D1604 v1
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
GOOSE function block to receive a
switching device
GOOSEXLNRCV - -
18.4.13.2 Functionality
GUID-5AC7DE11-CB95-4565-A8AE-FB23D59FD717 v1
The GOOSE XLN Receive component is used to collect information from another
device’s XCBR/XSWI logical node sent over process bus via GOOSE. The
GOOSE XLN Receive component includes 12 different outputs (and their
respective channel valid bits) with defined names to ease the 61850 mapping of the
GOOSE signals in the configuration process.
1MRK 505 394-UEN A Section 18
Station communication
Line differential protection RED650 2.2 IEC 663
Technical manual
To Next Page
Loading...
