Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 85
System Commands
Memory Subsystem (:MEMory)
This command loads a list sweep file.
Key Entry Load From Selected File
:MOVE
Supported All Models
:MEMory:MOVE "<src_file>","<dest_file>"
This command renames the requested file in the memory catalog.
Key Entry Rename File
Remarks Refer to “File Name Variables” on page 12 for information on the file name syntax.
:SIZE
Supported All Models
:MEMory:SIZE? <"filename">
This command returns the size of the file named <"filename"> in bytes or a –1, if the file does not
exist. If the MSUS or directory is invalid, an “ERROR: –257, File name error” will be reported.
:STATe:COMMent
Supported All Models
:MEMory:STATe:COMMent <reg_num>,<seq_num>,"<comment>"
:MEMory:STATe:COMMent? <reg_num>,<seq_num>
This command lets you to add a descriptive comment to the saved state <reg_num>,<seq_num>.
Comments can be up to 55 characters long.
Key Entry Add Comment To Seq[n] Reg[nn]
:STORe:LIST
Supported All Models
:MEMory:STORe:LIST "<file name>"
This command stores the current list sweep data to a file.
Key Entry Store To File
:CATalog
Supported All Models
:MMEMory:CATalog? "<msus>"
This command outputs a list of the files from the specified file system.
The variable "<msus>" (mass storage unit specifier) represents "<file system>". The file systems and
types are shown in Table 1- 4 on page 14.
To Next Page
Loading...
