166 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
SCPI Compatibility
Overview
Overview
This Chapter contains the following major sections:
The following list shows the supported models along with the language type for each one:
These commands and programming codes are separated into compatible and non- compatible sections.
In many instances, the non- compatible section has the least number of commands/codes, thus
providing a more time- efficient way of determining whether or not a command/code is supported by
the N5181A/82A.
In some cases, SCPI commands are only partially supported. This usually occurs due to a variance in
parameters between the N5181A/82A and other signal generator models. When this condition occurs,
the SCPI command will appear in both the compatible and non- compatible sections showing the exact
SCPI command syntax that is supported and unsupported.
In addition to providing the compatible command/code listing, this chapter also provides you with
N5181A/82A SCPI commands that lets you change the signal generator identification output (see
“:SYSTem:IDN” on page 167), select a compatible programming language (see “:SYSTem:LANGuage” on
page 168), and query the signal generator for errors (see “:SYSTem:ERRor[:NEXT]” on page 168).
N5181A/82A SCPI commands
E44xxB SCPI commands
E4428C/38C SCPI commands
8648A/B/C/D SCPI commands
8656B programming codes
8657A/B/D/J programming codes
To Next Page
Loading...
