44 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Basic Function Commands
List/Sweep Subsystem ([:SOURce])
:LIST:DWELl:TYPE
Supported All Models
[:SOURce]:LIST:DWELl:TYPE LIST|STEP
[:SOURce]:LIST:DWELl:TYPE?
This command toggles the dwell time for the list sweep points between the values defined in the list
sweep and the value for the step sweep.
LIST This choice selects the dwell times from the list sweep. Refer to “:LIST:DWELl” on
page 43 for setting the list dwell points.
STEP This choice selects the dwell time from the step sweep. Refer to “:SWEep:DWELl”
on page 48 for setting the step dwell.
*RST LIST
Key Entry Dwell Type List Step
:LIST:FREQuency
Supported All Models
[:SOURce]:LIST:FREQuency <value>{,<value>}
[:SOURce]:LIST:FREQuency?
This command sets the frequency values for the current list sweep points.
The maximum number of list sweep points is 1,601.
The variable <value> is expressed in units of Hertz.
The setting enabled by this command is not affected by signal generator power- on, preset, or *RST.
Option 501 is specific to the N5181A.
:LIST:FREQuency:POINts
Supported All Models
[:SOURce]:LIST:FREQuency:POINts?
This command queries the current list sweep file for the number of frequency points.
Range Option 501: 1.0E3–1E9
Option 503: 1.0E3–3E9
Option 506: 1.0E3–6E9
To Next Page
Loading...
