58 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Basic Function Commands
Tsweep Subsystem ([:SOURce])
Tsweep Subsystem ([:SOURce])
:TSWeep
Supported All Models
[:SOURce]:TSWeep
This command aborts the current sweep, then either arms or arms and starts a single list, depending
on the trigger type.
The command performs the following:
• arms a single sweep when BUS, EXTernal, or Trigger KEY is the trigger source selection
• arms and starts a single sweep when IMMediate is the trigger source selection
Key Entry Single Sweep
To Next Page
Loading...
