Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 109
System Commands
System Subsystem (:SYSTem)
Key Entry Save User Preset
Remarks Only one user- defined preset file can be saved. Subsequent saved user- defined
preset files will overwrite the previously saved file.
For a comparison of the SCPI preset commands, refer to Table 3- 1, “Preset SCPI
Commands Overview,” on page 106.
:SECurity:DISPlay
Supported All Models
:SYSTem:SECurity:DISPlay ON|OFF|1|0
:SYSTem:SECurity:DISPlay?
This command enables or disables the secure display mode.
On(1) This selection turns the signal generator display back on, showing the current
settings. Cycling the signal generator power also restores the display, however the
current settings may change depending on the power- on configuration choice. See
“:PON:TYPE” on page 105 for information on the power- on choices available.
OFF(0) This selection blanks the signal generator’s display, hiding the settings and
disabling the front panel keys. While in this mode, the display shows
*** SECURE DISPLAY ACTIVATED ***.
For more information about security functions, refer to the N5181A/82A Agilent MXG Signal
Generators User’s Guide.
Example
:SYST:SEC:DISP OFF
The preceding example enables the secure display mode.
*RST 1
Range N/A
Key Entry Activate Security Display
:SECurity:ERASeall
Supported All Models
:SYSTem:SECurity:ERASeall
This command removes all user files, flatness correction files, and baseband generator files. In
addition, all table editor files are returned to their original factory values.
This command differs from the :DELete:ALL command, which does not reset table editors to factory
values. For more information about security functions, refer to the N5181A/82A Agilent MXG Signal
Generators User’s Guide.
Key Entry Erase All
To Next Page
Loading...
