154 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Component Test Digital Commands
Dual ARB Subsystem–Option 651/652/654 ([:SOURce]:RADio[1]:ARB)
:SCALing
Supported N5182A with Option 651/652/654
[:SOURce]:RADio[1]:ARB:SCALing "<file_name>",<value>
This command scales the designated "<file_name>" waveform file while it is being played by the
dual ARB player. The variable <value> is expressed as a percentage, 1–100%. For information on file
name syntax, see “File Name Variables” on page 12.
Unlike runtime scaling (:RSCaling), Scaling is additive and permanent. You cannot scale up. If you
scale a waveform file by 60% and then scale it again to 80% you will scale down the 60% waveform
file. For more information about waveform file scaling, refer to the User’s Guide.
Example
:RAD:ARB:SCAL "Test_Data", 50
The preceding example applies a 50% scaling factor to the Test_Data waveform file.
Range 1–100
Remarks Refer to “File Name Variables” on page 12 for information on the file name syntax.
Remarks Refer to “File Name Variables” on page 12 for information on the file name syntax.
:SCLock:RATE
Supported N5182A with Option 651/652/654
[:SOURce]:RADio[1]:ARB:SCLock:RATE <value>
[:SOURce]:RADio[1]:ARB:SCLock:RATE?
This command sets the sample clock rate for the dual ARB format.
The variable <value> is expressed in units of hertz.
*RST +1.25000000E+008
Range 1–1.25E8
Key Entry ARB Sample Clock
Key Entry Scaling Scale Waveform Data
Range OSR Option 651: 4E0 – 125E8
OSR Option 652: 4E0 – 125E8
OSR Option 654: 4E0 – 125E8
Scale: 0–1
To Next Page
Loading...
