104 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
System Subsystem (:SYSTem)
:LANGuage
Supported All
:SYSTem:LANGuage "SCPI"|"COMP"|"8648"
:SYSTem:LANGuage?
This command sets the remote language for the signal generator.
SCPI This choice provides compatibility for SCPI commands.
COMP This choice provides compatibility for the 8656B, 8657A/B signal generator which
is supported by using the GPIB interface.
8648 This choice provides compatibility for the 8648A/B/C/D signal generator which is
supported only through a GPIB interface.
Remarks The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
For more information on supported SCPI commands and programming codes, refer
to the Programming Compatibility Guide.
:LICense:INSTall
Supported All
:SYSTem:LICense:INSTall <license_line>|<block_of_license_lines>
This command installs the licenses into the signal generator.
<license_line> This choice installs a license line.
<block_of_license_lines> This choice installs a block of license lines.
Example
:SYST:LIC:INST "FEATURE 403 aspk 0 permanent 0 389D66FB107E9B02
HOSTID=N5182A,US00000068"
The preceding example installs license "FEATURE 403 aspk 0 permanent 0 389D66FB107E9B02
HOSTID=N5182A,US00000068", into the signal generator.
or to install a block of license files:
:SYST:LIC:INST #210Qaz37pY9oL
The preceding SCPI command shows an example of the syntax for installing a block of licenses into
the signal generator. For more on handling block data, refer to the Programming Guide.
NOTE The data, Qaz37pY9oL, in the above command are not valid and are shown for example
purposes only. Typically, ascii characters representing data are unprintable.
For additional information on downloading and installing licenses for applications, refer to
the Agilent License Manager at http://www.agilent.com/find/LicenseManager.
Key Entry SCPI 8656B,8657A/B 8648A/B/C/D
To Next Page
Loading...
