34 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Basic Function Commands
Frequency Subsystem ([:SOURce])
:FREQuency:CHANnels:NUMBer
Supported All Models
[:SOURce]:FREQuency:CHANnels:NUMBer <number>
[:SOURce]:FREQuency:CHANnels:NUMBer?
This command sets the frequency of the signal generator by specifying a channel number of a given
frequency band.
The channel band and channel state must be enabled for this command to work. Refer to
“:FREQuency:CHANnels[:STATe]” on page 35.
Example
:FREQ:CHAN:NUMB 24
The preceding example sets the channel number to 24 for the current band.
*RST +1
PCS Mobile GSM 450 Mobile GSM 480 Mobile GSM 850 Mobile
NADC Mobile 800MHz Mobile 1500MHz Mobile
Tetra Mobile 380/390 Tetra Mobile 410/420 Tetra Mobile 450/460
Tetra Mobile 870/876
Range P- GSM Base/Mobile: 1–24
E- GSM and R- GSM Base/Mobile: 1–1023
DCS Base/Mobile: 512–885
PCS Base/Mobile: 512–900
GSM- 450 Base/Mobile: 259–293
GSM- 480 Base/Mobile: 306–340
GSM- 850 Base/Mobile: 128–251
NADC Base/Mobile: 1–1023
800MHz Base/Mobile: 0–640
1500MHz Base/Mobile: 0–960
TETRA 380/390 Mobile: 3600–4000
TETRA 390/4000 Base: 3600–4000
TETRA 410/420 Mobile: 800–1200
TETRA 420/430 Base: 800–1200
TETRA 460/470: 2400 through 2800 2400–2800
TETRA 870/876 Mobile: 600–640
TETRA 915/921 Base: 600–940
To Next Page
Loading...
