112 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
System Subsystem (:SYSTem)
SRAM All addressable locations will be overwritten with random characters.
HARD DISK All addressable locations will be overwritten with a single character and then a
random character.
FLASH MEMORY The flash blocks will be erased.
Key Entry Erase and Sanitize All
:SSAVer:DELay
Supported All
:SYSTem:SSAVer:DELay <value>
:SYSTem:SSAVer:DELay?
This command sets the amount of time before the display light or display light and text is switched
off. This will occur if there is no input via the front panel during the delay period.
The variable <value> is a whole number measured in hours.
Range 1–12
Key Entry Screen Saver Delay:
Remarks The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
Refer to “:SSAVer:MODE” on page 112 for selecting the screen saver mode.
:SSAVer:MODE
Supported All
:SYSTem:SSAVer:MODE LIGHt|TEXT
:SYSTem:SSAVer:MODE?
This command toggles the screen saver mode between light only or light and text.
LIGHt This choice enables only the light to turn off during the screen saver operation
while leaving the text visible on the darkened screen.
TEXT This choice enables both the display light and text to turn off during the screen
saver operation.
Key Entry Screen Saver Mode
Remarks The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
:SSAVer:STATe
Supported All
:SYSTem:SSAVer:STATe ON|OFF|1|0
:SYSTem:SSAVer:STATe?
This command enables or disables the display screen saver.
To Next Page
Loading...
