Agilent Technologies n5181a - Digital Modulation Subsystem-N5182 A ([:Source]); Burst:state; DM:correction:optimization; DM:external:alc:bandwidth|Bwidth

To Next Page

To Previous Page

24 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference

Basic Function Commands

Digital Modulation Subsystem—N5182A ([:SOURce])

:BURSt:STATe

Supported N5182A

[:SOURce]:BURSt:STATe ON|OFF|1|0

[:SOURce]:BURSt:STATe?

This command enables or disables the burst envelope function.

*RST 0

Key Entry Burst Envelope Off On

:DM:CORRection:OPTimization

Supported N5182A

[:SOURce]:DM:CORRection:OPTimization RFOut|EXTernal

[:SOURce]:DM:CORRection:OPTimization?

This command enables the internal optimized path to accommodate I/Q signals.

EXT This choice enables the Baseband Generator to external I/Q output path, applies

correction terms, and provides a calibrated signal at the IQ output. When the

I/Q Output is selected, the RF signals at the RF Output are uncalibrated.

RFO This choice enables the Baseband Generator to RF output path, applies correction

terms, and provides a calibrated signal at the RF output. When the RF Output is

selected, the I/Q signals at the I/Q Output are uncalibrated.

*RST RFO

Key Entry I/Q Correction Optimized Path

:DM:EXTernal:ALC:BANDwidth|BWIDth

Supported N5182A

NOTE Refer to the Programming Compatibility Guide for information on this command. This

command was replaced by the “:ALC:BANDwidth|BWIDth” command shown in Chapter 6.

Other manuals for Agilent Technologies n5181a