Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 77
System Commands
IEEE 488.2 Common Commands
*RST
Supported All Models
*RST
The Reset (RST) command resets most signal generator functions to factory- defined conditions.
Remarks Each command shows the *RST value if the setting is affected.
The settings enabled by this command is not affected by a signal generator
power- on, preset, or *RST.
*RST uses the factory preset state which is better for automated testing, for
example sweep mode is set to single.
For a comparison of the SCPI preset commands, refer to Table 3- 1, “Preset SCPI
Commands Overview,” on page 106.
*SAV
Supported All Models
*SAV <reg>,<seq>
The Save (SAV) command saves signal generator settings to the specified memory register <reg> of
the specified sequence <seq>.
Remarks The save function does not save all signal generator settings. Refer to the
N5181A/82A Agilent MXG Signal Generators User’s Guide for more information
on the save function. Refer to “*RCL” on page 76 for information on recalling
saved signal generator settings.
*SRE
Supported All Models
*SRE <data>
The Service Request Enable (SRE) command sets the value of the Service Request Enable Register.
The variable <data> is the decimal sum of the bits that will be enabled. Bit 6 (value 64) is ignored
and cannot be set by this command.
Range 0–255
Remarks Refer to the Programming Guide for more information.
Entering values from 64 to 127 is equivalent to entering values from 0 to 63.
The setting enabled by this command is not affected by signal generator preset or
*RST. However, cycling the signal generator power will reset it to zero.
Key Entry RECALL Reg Select Seq:
Range Registers: 0–99 Sequences: 0–9
Key Entry Save Reg Save Seq[n] Reg[nn]
To Next Page
Loading...
