40 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Basic Function Commands
Frequency Subsystem ([:SOURce])
:PHASe[:ADJust]
Supported All Models
[:SOURce]:PHASe[:ADJust] <value><unit>
[:SOURce]:PHASe[:ADJust]?
This command adjusts the phase of the modulating signal.
The query will only return values in radians.
*RST +0.00000000E+000
Key Entry Adjust Phase
:ROSCillator:BANDwidth:EXTernal
Supported All Models
[:SOURce]:ROSCillator:BANDwidth:EXTernal
<value>[<units>]|NARRow|WIDE|MINimum|MAXimum|
[:SOURce]:ROSCillator:BANDwidth:EXTernal? |MINimum|MAXimum|
This command selects the external frequency bandwidth as the source for the measurement.
For values greater than 9.5 Hz, 73 Hz is used.
*RST +9.50000000E+000
Range .5 or 73 Hz
Key Entry Ref Oscillator Ext Bandwidth
:ROSCillator:FREQuency:EXTernal
Supported All Models
[:SOURce]:ROSCillator:FREQuency:EXTernal <value>
[:SOURce]:ROSCillator:FREQuency:EXTernal?
This command makes External Ref Frequency the active function. The value that you enter sets the
frequency of the external reference oscillator.
*RST +1.0000000000000E+07 Hz
Range +1.0000000000000E+06 to +5.0000000000000E+07 Hz
Key Entry Ref Oscillator Ext Freq
Remarks If the entered frequency does not match the frequency of the entered reference,
an unlocked condition will occur and an error message will appear.
Range Radians: –3.14 to 3.14RAD Degrees: –180 to 179DEG
To Next Page
Loading...
