80 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
Memory Subsystem (:MEMory)
are files in the directory list. Each file listing parameter will be in the following form:
"<file name>,<file type>,<file size>"
Example Output
1818624,519962624,"SEQ1_TEST,SEQ,206","SEQ_TEST,SEQ,169"
Key Entry SEQ
Remarks Refer to “File Name Variables” on page 12 for information on the file name syntax.
:CATalog:STATe?
Supported All Models
:MEMory:CATalog:STATe?
This query outputs a list of the state files. The return data will be in the following form:
<mem used>,<mem free>{,"<file listing>"}
The signal generator will return the two memory usage parameters and as many file listings as there
are files in the directory list. Each file listing parameter will be in the following form:
"<file name,file type,file size>"
Example Output
1818624,519962624,"0_00,STAT,641"
Key Entry State
Remarks Refer to “File Name Variables” on page 12 for information on the file name syntax.
The :MEM:CAT:STAT command requires the use of registry number and sequence
number variables. The ranges are 0- 99 for <reg_num> and 0-9 for <seq_num>.
:CATalog:UFLT?
Supported All Models
:MEMory:CATalog:UFLT?
This query outputs a list of the user- flatness correction files. The return data will be in the following
form:
<mem used>,<mem free>{,"<file listing>"}
The signal generator will return the two memory usage parameters and as many file listings as there
are files in the directory list. Each file listing parameter will be in the following form:
"<file name,file type,file size>"
Example Output
1818624,519962624,"FLAT_1,UFLT,16","LAST,UFLT,16"”
Key Entry User Flatness
Remarks Refer to “File Name Variables” on page 12 for information on the file name syntax.
To Next Page
Loading...
