Agilent Technologies n5181a - Configuring a Swept Output

22 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Basic Function Commands
Correction Subsystem ([:SOURce]:CORRection)
:FLATness:STEP:POINts
Supported All Models
[:SOURce]:CORRection:FLATness:STEP:POINts <points> |MAXimum|MINimum|DEFault|
[:SOURce]:CORRection:FLATness:STEP:POINts?[MAXimum|MINimum]
This command is used to define the number of points in the user flatness calibration step array. See
also, “:FLATness:STEP:STARt” on page 22 and “:FLATness:STEP:STOP” on page 22.
Key Entry # Points 2
:FLATness:STEP:STARt
Supported All Models
[:SOURce]:CORRection:FLATness:STEP:STARt <freq><unit> |MAXimum|MINimum|DEFault|
[:SOURce]:CORRection:FLATness:STEP:STARt? [MAXimum|MINimum]
This command sets the start frequency for the user flatness calibration step array. See also,
“:FLATness:STEP:POINts” on page 22 and “:FLATness:STEP:STOP” on page 22.
Key Entry Freq Start
Remarks Options 501 is specific to the N5181A.
:FLATness:STEP:STOP
Supported All Models
[:SOURce]:CORRection:FLATness:STEP:STOP <freq><unit> |MAXimum|MINimum|DEFault|
[:SOURce]:CORRection:FLATness:STEP:STOP? [MAXimum|MINimum]
This command sets the stop frequency for the user flatness calibration step array. See also,
“:FLATness:STEP:POINts” on page 22 and “:FLATness:STEP:STARt” on page 22.
Key Entry Freq Stop
Remarks Options 501 is specific to the N5181A.
*RST Option 501: +1.0000000000000E+09
Option 503: +3.0000000000000E+09
Option 506: +6.0000000000000E+09
Range Option 501: 100kHz–1GHz
Option 503: 100kHz–3GHz
Option 506: 100kHz–6GHz
*RST Option 501: +1.0000000000000E+09
Option 503: +3.0000000000000E+09
Option 506: +6.0000000000000E+09
Range Option 501: 100kHz–1GHz
Option 503: 100kHz–3GHz
Option 506: 100kHz–6GHz