Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 117
System Commands
Trigger Subsystem
*RST IMM
Remarks The wait for the BUS, EXTernal, or KEY trigger can be bypassed by sending the
:TRIGger[:SEQuence][:IMMediate] command.
Example
:TRIG:SOUR BUS
The preceding example sets the sweep trigger source to BUS.
*RST IMM
:TRIGger[:SEQuence]:TIMer
Supported All Models
:TRIGger[:SEQuence]:TIMer <period>
:TRIGger[:SEQuence]:TIMer?
This command sets the period of the timer trigger.
*RST 1 ms
Range .5ms–1000s
Key Entry Trig Timer Period
:TRIGger[:SEQuence][:IMMediate]
Supported All Models
:TRIGger[:SEQuence][:IMMediate]
This event command causes an armed List or Step sweep to immediately start without the selected
trigger occurring.
Key Entry Bus Free Run Ext Trigger Key Timer Trigger
To Next Page
Loading...
