Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 145
Component Test Digital Commands
Dual ARB Subsystem–Option 651/652/654 ([:SOURce]:RADio[1]:ARB)
:HEADer:SAVE
Supported N5182A with Option 651/652/654
[:SOURce]:RADio[1]:ARB:HEADer:SAVE
This command saves the header information to the file header used by this modulation format.
Key Entry Save Setup To Header
Remarks A waveform must be selected for this command to function.
:IQ:MODulation:ATTen
Supported N5182A with Option 651/652/654
[:SOURce]:RADio[1]:ARB:IQ:MODulation:ATTen <value>
[:SOURce]:RADio[1]:ARB:IQ:MODulation:ATTen?
This command sets the attenuation level of the I/Q signals being modulated through the signal
generator RF path.
The variable <value> is expressed in units of decibels (dB).
*RST Varies (box dependent)
Range 0−40
Key Entry Modulator Atten Manual Auto
:IQ:MODulation:ATTen:AUTO
Supported N5182A with Option 651/652/654
[:SOURce]:RADio[1]:ARB:IQ:MODulation:ATTen:AUTO ON|OFF|1|0
[:SOURce]:RADio[1]:ARB:IQ:MODulation:ATTen:AUTO?
This command enables or disables the I/Q attenuation auto mode.
ON (1) This choice enables the attenuation auto mode which optimizes the modulator
attenuation for the current conditions.
OFF (0) This choice holds the attenuator at its current setting or at a selected value. Refer
to “:IQ:MODulation:ATTen” on page 145 for setting the attenuation value.
*RST 1
Key Entry Modulator Atten Manual Auto
To Next Page
Loading...
