Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 39
Basic Function Commands
Frequency Subsystem ([:SOURce])
:FREQuency:STOP
Supported All Models
[:SOURce]:FREQuency:STOP <value><unit>
[:SOURce]:FREQuency:STOP?
This command sets the last frequency point in a step sweep.
Key Entry Freq Stop
Remarks Option 501 is specific to the N5181A.
:FREQuency[:CW]
Supported All Models
[:SOURce]:FREQuency[:CW] <value><unit>
[:SOURce]:FREQuency[:CW]?
This command sets the signal generator output frequency for the CW frequency mode.
Key Entry Freq
Remarks To set the frequency mode to CW, refer to “:FREQuency:MODE” on page 36.
Option 501 is specific to the N5181A.
:PHASe:REFerence
Supported All Models
[:SOURce]:PHASe:REFerence
This command sets the current output phase as a zero reference.
Subsequent phase adjustments are set relative to the new reference.
Key Entry Phase Ref Set
*RST Option 501: +1.0000000000000E+09
Option 503: +3.0000000000000E+09
Option 506: +6.0000000000000E+09
Range Option 501: 100kHz–1GHz
Option 503: 100kHz–3GHz
Option 506: 100kHz–6GHz
*RST Option 501: +1.0000000000000E+09
Option 503: +3.0000000000000E+09
Option 506: +6.0000000000000E+09
Range Option 501: 100kHz–1GHz
Option 503: 100kHz–3GHz
Option 506: 100kHz–6GHz
To Next Page
Loading...
