90 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
Output Subsystem (:OUTPut)
Remarks Some modulation types can be simultaneously enabled such as pulse and AM.
An annunciator on the signal generator is always displayed to indicate whether
modulation is switched on or off.
:PROTection[:STATe]
Supported All
:OUTPut:PROTection[:STATe] ON|OFF|1|0
:OUTPut:PROTection[:STATe]?
This command enables or disables the reverse power protection (RPP) circuit on the RF output.
CAUTION The RPP is used to protect the output amplifiers in the source by tripping a relay
whenever an external high level RF signal is detected on the RF output. When the relay
is tripped the output signal of the source is disabled and a warning message is
displayed.
*RST 1
Key Entry Output Off On Auto
[:STATe]
Supported All
:OUTPut[:STATe] ON|OFF|1|0
:OUTPut[:STATe]?
This command enables or disables the RF output.
*RST 0
Key Entry RF On/Off
Remarks Although you can configure and engage various modulations, no signal is available
at the RF OUTPUT connector until this command is executed.
An annunciator is always displayed on the signal generator to indicate whether
the RF output is switched on or off.
To Next Page
Loading...
