106 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
System Subsystem (:SYSTem)
LAST This choice retains the settings at the time the signal generator was last powered
down.
USER This choice sets the power on state to be the user preset value.
Key Entry Power On Last Preset
Remarks The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
For a comparison of the SCPI preset commands, refer to Table 3- 1, “Preset SCPI
Commands Overview,” on page 106.
:PRESet
NOTE If this SCPI command is not responding as expected, use the E4428C/38C compatibility
command: :SYST:PRESet:TYPE:NORMal to return the front panel Preset key to its factory
default functionality.
Supported All
SYSTem:PRESet
This command returns the signal generator to a set of defined conditions. It is equivalent to pressing
the front panel Preset hardkey.
Key Entry Preset
Remarks The defined conditions are either factory- or user- defined.
For a comparison of the SCPI preset commands, refer to Table 3- 1, “Preset SCPI
Commands Overview,” on page 106.
Table 3-1 Preset SCPI Commands Overview
Command Description Remarks
*RST This IEEE 488.2 Common Command uses the
factory preset settings for the instrument
preset.
Optimized for automated
testing
:SYSTem:PRESet:PERSistent Only the instrument’s persistent parameters
are returned to factory default value.
:SYSTem:PON:TYPE
PRESet|LAST|USER
:SYSTem:PON:TYPE?
Sets the power on state (PON) to be the same
as the front panel green Preset hardkey, or
the last state, or to the user state.
:SYSTem:PRESet Performs the same preset as currently set for
the front panel green Preset hardkey.
:SYSTem:PRESet[:USER]:SAVE Saves the current instrument state as the user
preset state.
To Next Page
Loading...
