Agilent Technologies n5181a - Trigger[:Source]:External:delay:state; Trigger[:Source]:External:slope

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 161
Component Test Digital Commands
Dual ARB Subsystem–Option 651/652/654 ([:SOURce]:RADio[1]:ARB)
The delay does not occur until you turn it on (see “:TRIGger[:SOURce]:EXTernal:DELay:STATe” on
page 161). You can set the delay value either before or after turning it on.
For more information on configuring an external trigger source and to select external as the trigger
source, see “:TRIGger[:SOURce]” on page 160.
The unit of measurement for the variable <value> is in seconds (nsec–sec).
*RST +1.00000000E−003
Range 1E−8 to 3E1
Key Entry Ext Delay Time
:TRIGger[:SOURce]:EXTernal:DELay:STATe
Supported N5182A with Option 651/652/654
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:DELay:STATe ON|OFF|1|0
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:DELay:STATe?
This command enables or disables the operating state of the external trigger delay function.
For setting the delay time, see “:TRIGger[SOURce]:EXTernal:DELay” on page 160, and for more
information on configuring an external source, see“:TRIGger[:SOURce]” on page 160.
*RST 0
Key Entry Ext Delay Off On
:TRIGger[:SOURce]:EXTernal:SLOPe
Supported N5182A with Option 651/652/654
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:SLOPe POSitive|NEGative
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:SLOPe?
This command sets the polarity for an external trigger signal while using the continuous, single
triggering mode. To set the polarity for gating, see “:TRIGger:TYPE:GATE:ACTive” on page 158.
The POSitive and NEGative selections correspond to the high (positive) and low (negative) states of
the external trigger signal. For example, when you select POSitive, the waveform responds (plays)
during the high state of the trigger signal. When the Agilent MXG receives multiple trigger
occurrences when only one is required, the signal generator uses the first trigger and ignores the
rest.
For more information on configuring an external trigger source and to select external as the trigger
source, see “:TRIGger[:SOURce]” on page 160.
*RST NEG
Key Entry Ext Polarity Neg Pos