Agilent Technologies n5181a - Display Subsystem (:Display); Annotation:amplitude:unit; Annotation:clock:date:format; Annotation:clock[:State]

To Next Page

To Previous Page

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 71

System Commands

Display Subsystem (:DISPlay)

:ANNotation:AMPLitude:UNIT

Supported All Models

:DISPlay:ANNotation:AMPLitude:UNIT?

This command sets the displayed front panel amplitude units.

If the amplitude reference state is set to on, the query returns units expressed in dB. Setting any

other unit will cause a setting conflict error stating that the amplitude reference state must be set to

off. Refer to, “:REFerence:STATe” on page 55 for more information.

*RST DBM

:ANNotation:CLOCk:DATE:FORMat

Supported All Models

:DISPlay:ANNotation:CLOCk:DATE:FORMat MDY|DMY

:DISPlay:ANNotation:CLOCk:DATE:FORMat?

This command enables the selection of the date format. The choices are month- day- year (MDY) or

day- month- year (DMY) format.

Remarks The setting enabled by this command is not affected by signal generator power- on,

preset, or *RST.

:ANNotation:CLOCk[:STATe]

Supported All Models

:DISPlay:ANNotation:CLOCk[:STATe] ON|OFF|1|0

:DISPlay:ANNotation:CLOCk[:STATe]?

This command enables or disables the digital clock view in the lower right side of the front panel

display.

Remarks The setting enabled by this command is not affected by signal generator power- on,

preset, or *RST.

:BRIGhtness

Supported All Models

:DISPlay:BRIGhtness <value>

:DISPlay:BRIGhtness?

This command sets the display brightness (intensity). The brightness can be set to the minimum level

(0.02), maximum level (1), or in between by using fractional numeric values (0.03–0.99).

Range 0.02–1

Key Entry Brightness

Other manuals for Agilent Technologies n5181a