42 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Basic Function Commands
List/Sweep Subsystem ([:SOURce])
List/Sweep Subsystem ([:SOURce])
A complete sweep setup requires commands from other subsystems. Table 2- 2 shows the function
and location of these other commands.
Table 2-2 Location of Commands from the other Subsystems
Sweep Type Function Command Location Key Entry under
Sweep/List key
List and Step Start/stop frequency sweep “:FREQuency:MODE” on page 36 Freq Off On
Start/stop amplitude sweep “:MODE” on page 54 Amptd Off On
Start/stop frequency and
amplitude sweep
a
a.Execute both commands to start or stop a frequency and amplitude sweep.
“:MODE” on page 54
“:FREQuency:MODE” on page 36
Freq & Amptd
Off On
Enables or Disables the
waveform sweep
“[:STATe]” on page 164 Waveform Off On
Set up and control sweep
triggering
b
b.For point to point triggering, see “:LIST:TRIGger:SOURce” on page 46.
“Trigger Subsystem” on page 115 See the “Trigger
Subsystem”
List Load a list sweep file “:LOAD:LIST” on page 88 and
page 88
Load From Selected
File
Store list sweep data to a file “:STORe:LIST” on page 85 and
page 85
Store To File
Selects the waveform for the
current waveform sequence
“:LIST:WAVeform” on page 48 no softkey
Step Start frequency sweep “:FREQuency:STARt” on page 38 Freq Start
Store list sweep data to a file “:STORe:LIST” on page 85 and
page 85
Store To File
Start amplitude sweep “:STARt” on page 55 Amptd Start
Stop amplitude sweep “:STOP” on page 56 Amptd Stop
To Next Page
Loading...
