78 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
IEEE 488.2 Common Commands
*SRE?
Supported All Models
*SRE?
The Service Request Enable (SRE) query returns the value of the Service Request Enable Register.
Range 0–63 or 128–191
Remarks Refer to the Programming Guide for more information.
*STB?
Supported All Models
*STB?
The Read Status Byte (STB) query returns the value of the status byte including the master summary
status (MSS) bit.
Range 0–255
Remarks Refer to the Programming Guide for more information.
*TRG
Supported All Models
*TRG
The Trigger (TRG) command triggers the device if BUS is the selected trigger source, otherwise, *TRG
is ignored.
*TST?
Supported All Models
*TST?
The Self- Test (TST) query initiates the internal self- test and returns one of the following results:
0 This shows that all tests passed.
1 This shows that one or more tests failed.
Key Entry Run Complete Self Test
*WAI
Supported All Models
*WAI
The Wait- to- Continue (WAI) command causes the signal generator to wait until all pending
commands are completed, before executing any other commands.
To Next Page
Loading...
