Agilent Technologies n5181a - Setting the Baseband Frequency Offset

To Next Page

To Previous Page

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 67

System Commands

Communication Subsystem (:SYSTem:COMMunicate)

Key Entry RFC NETBIOS Naming Off On

:LAN:SUBNet

Supported All

:SYSTem:COMMunicate:LAN:SUBNet "<ipstring>"

:SYSTem:COMMunicate:LAN:SUBNet?

This command sets the signal generator’s local area network (LAN) subnet mask address for your

internet protocol (IP) network connection.

NOTE An error will occur if the IP address, Gateway, and subnet mask have conflicting settings.

Key Entry Subnet Mask

Remarks The SCPI query returns the current setting, not the saved setting.

Other manuals for Agilent Technologies n5181a