94 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
Status Subsystem (:STATus)
:QUEStionable:CALibration:CONDition
Supported All
:STATus:QUEStionable:CALibration:CONDition?
This query returns the decimal sum of the bits in the Data Questionable Calibration Condition
Register. For example, if the DCFM or DCΦM zero calibration fails (bit 0), a value of 1 is returned.
Range 0–32767
Remarks The data in this register is continuously updated and reflects the current
conditions.
Refer to the Programming Guide for more information.
:QUEStionable:CALibration:ENABle
Supported All
:STATus:QUEStionable:CALibration:ENABle <value>
:STATus:QUEStionable:CALibration:ENABle?
This command determines which bits in the Data Questionable Calibration Event Register will set the
calibration summary bit (bit 8) in the Data Questionable Condition Register.
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0–32767
Remarks Refer to the Programming Guide for more information.
:QUEStionable:CALibration:NTRansition
Supported All
:STATus:QUEStionable:CALibration:NTRansition <value>
:STATus:QUEStionable:CALibration:NTRansition?
This command determines which bits in the Data Questionable Calibration Condition Register will set
the corresponding bit in the Data Questionable Calibration Event Register when that bit has a
negative transition (1 to 0).
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0–32767
Remarks Refer to the Programming Guide for more information.
:QUEStionable:CALibration:PTRansition
Supported All
:STATus:QUEStionable:CALibration:PTRansition <value>
:STATus:QUEStionable:CALibration:PTRansition?
This command determines which bits in the Data Questionable Calibration Condition Register will set
the corresponding bit in the Data Questionable Calibration Event Register when that bit has a
positive transition (0 to 1).
To Next Page
Loading...
