Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 163
Component Test Digital Commands
Dual ARB Subsystem–Option 651/652/654 ([:SOURce]:RADio[1]:ARB)
:WAVeform:NHEAders
Supported N5182A with Option 651/652/654
[:SOURce]:RADio:ARB:WAVeform:NHEaders "WFM1:file_name"|"SEQ:filename"
[:SOURce]:RADio:ARB:WAVeform:NHEaders?
This command, for the dual ARB mode, allows for a fast selection of a segment or sequence
waveform file. No header information or settings are applied to the segment or sequence waveform
file when this command is used. This will improve the access or loading speed of the waveform file.
The file must be in volatile waveform memory (WFM1), or in the SEQ directory. If a file is in
non- volatile waveform memory (NVWFM), use the command “:COPY[:NAME]” on page 81 to copy files
to WFM1.
"WFM1:file_name" This variable names a waveform file residing in volatile memory:WFM1. For
information on the file name syntax, see “File Name Variables” on page 12.
"SEQ:filename" This variable names a sequence file residing in the catalog of sequence files. For
more information on the file name syntax, see “File Name Variables” on page 12.
Example
:RAD:ARB:WAV:NHE "Test_Data"
The preceding example selects the file Test_Data, without applying header settings.
[:STATe]
Supported N5182A with Option 651/652/654
[:SOURce]:RADio:ARB[:STATe] ON|OFF|1|0
[:SOURce]:RADio:ARB[:STATe]?
This command enables or disables the arbitrary waveform generator function.
*RST 0
Key Entry ARB Off On
To Next Page
Loading...
