Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 187
SCPI Compatibility
E4428C/38C Compatible Commands
E4428C/38C Compatible Commands
This section contains commands that have either been replaced or deleted from the E4428C/38C ESG
Signal Generators SCPI Command Reference.
NOTE The Agilent MXG has only one AM path; and only one internal and one external source. If
executed, the “2” path or “2” internal or external source commands will result in a “ERROR:
-113, Undefined Header” to be generated in the signal generator.
The Agilent MXG has only one EXT path. If the EXT2 source command is executed, it will be
accepted by the signal generator, but the results are the same as when the EXT[1] command
is executed, and Ext Pulse will be selected in the Agilent MXG.
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks
System Function Commands
IEEE Common Commands
*CLS ✓
*ESE <data>
*ESE?
✓
*ESR? ✓
*IDN? ✓
*OPC
*OPC?
✓
*RCL <reg_num> ✓
*RST ✓
*SAV <reg_num> ✓
*SRE <data>
*SRE?
✓
*STB? ✓
*TRG ✓
*TST? ✓
*WAI ✓
To Next Page
Loading...
