Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 97
System Commands
Status Subsystem (:STATus)
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0–32767
Remarks Refer to the Programming Guide for more information.
:QUEStionable:FREQuency[:EVENt]
Supported All
CAUTION This is a destructive read. The data in the register is latched until it is queried. Once
queried, the data is cleared.
:STATus:QUEStionable:FREQuency[:EVENt]?
This query returns the decimal sum of the bits in the Data Questionable Frequency Event Register.
Range 0–32767
Remarks The equivalent PTR or NTR filters must be set before the condition register can
set the corresponding bit in the event register.
Refer to the Programming Guide for more information.
:QUEStionable:NTRansition
Supported All
:STATus:QUEStionable:NTRansition <value>
:STATus:QUEStionable:NTRansition?
This command determines which bits in the Data Questionable Condition Register will set the
corresponding bit in the Data Questionable Event Register when that bit has a negative transition (1
to 0).
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0–32767
Remarks Refer to the Programming Guide for more information.
:QUEStionable:POWer:CONDition
Supported All
:STATus:QUEStionable:POWer:CONDition?
This query returns the decimal sum of the bits in the Data Questionable Power Condition Register.
For example, if the RF output signal is unleveled (bit 1), a value of 2 is returned.
Range 0–32767
Remarks The data in this register is continuously updated and reflects current conditions.
Refer to the Programming Guide for more information.
To Next Page
Loading...
