62 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
Calibration Subsystem (:CALibration)
:IQ:STOP
Supported N5182A
:CALibration:IQ:STOP <value><unit>
:CALibration:IQ:STOP?
This command sets the stop frequency and automatically sets the calibration type to User for an I/Q
calibration.
The stop frequency must be greater than the current value of the start frequency.
Key Entry Stop Frequency
Remarks The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
:IQ:TYPE
Supported N5182A
:CALibration:IQ:TYPE DC|USER|FULL
:CALibration:IQ:TYPE?
This command sets the IQ calibration type.
Key Entry Calibration Type DC User Full
*RST DC
Remarks The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
:IQ:[:USER]
Supported N5182A
:CALibration:IQ[:USER]
This command performs a IQ calibration according to the IQ calibration type. For information on
selecting the type of IQ calibration, refer to “:IQ:TYPE” on page 62.
Key Entry Execute Cal
Range Option 503: 100kHz–3GHz
Option 506: 100kHz–6GHz
To Next Page
Loading...
