Agilent Technologies n5181a - Storing, Loading, and Playing a Waveform Segment

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 65
System Commands
Communication Subsystem (:SYSTem:COMMunicate)
This entry defines the DNS server for the signal generator LAN connection.
Key Entry DNS Server
Remarks The SCPI query returns the current setting, not the saved setting.
:LAN:GATeway
Supported All
:SYSTem:COMMunicate:LAN:GATeway "<ipstring>"
:SYSTem:COMMunicate:LAN:GATeway?
This command sets the gateway for local area network (LAN) access to the signal generator from
outside the current sub- network.
Key Entry Default Gateway
Remarks Using an empty string restricts access to the signal generator to local hosts on the
LAN.
The SCPI query returns the current setting, not the saved setting.
:LAN:HOSTname
Supported All
:SYSTem:COMMunicate:LAN:HOSTname "<string>"
:SYSTem:COMMunicate:LAN:HOSTname?
This command sets the signal generator’s local area network (LAN) connection hostname.
Key Entry Hostname
Remarks The SCPI query returns the current setting, not the saved setting.
:LAN:IDENtify
Supported All
:SYSTem:COMMunicate:LAN:IDENtify ON|OFF|1|0
This command controls the LAN identify feature.
ON(1) The command enables device identification by displaying the full- screen message
"Identify: <IP Address>" on the signal generator's front panel; the LAN Status
indicator will also show "IDENTIFY". For more information, refer to the
Programming Guide.
OFF(0) This command disables device identification by clearing the message on the signal
generator's front panel and returning the LAN Status indicator to display the
current network state. For more information, refer to the Programming Guide.