114 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
System Commands
Unit Subsystem (:UNIT)
Unit Subsystem (:UNIT)
:POWer
Supported All
:UNIT:POWer DBM|DBUV|DBUVEMF|V|VEMF|DB
:UNIT:POWer?
This command terminates an amplitude value in the selected unit of measure.
If the amplitude reference state is set to on, the query returns units expressed in dB and the dB
choice will be displayed. Setting any other unit will cause a setting conflict error stating that the
amplitude reference state must be set to off. Refer to, “:REFerence:STATe” on page 55 for more
information.
*RST DBM
Remarks All power values in this chapter are shown with dBm as the unit of measure. If a
different unit of measure is selected, replace dBm with the newly selected unit
whenever it is indicated for the value.
Key Entry dBm dBuV dBuVemf V mVem
f
dB
To Next Page
Loading...
