Agilent Technologies n5181a - Delete:all; Delete:binary; Delete:list; Delete:seq

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 83
System Commands
Memory Subsystem (:MEMory)
stored in the signal generator’s non-volatile memory (NVWFM).
Remarks Refer to “File Name Variables” on page 12 for information on the file name syntax.
:DELete:ALL
Supported All Models
CAUTION Using this command deletes all non- volatile user files including binary, list, state, and
flatness correction files, and any saved setups which use the front panel table editor.
However, this does not include files stored on the Option 651/652/654 ARB generator.
You cannot recover the files after executing this command.
:MEMory:DELete:ALL
This command clears the file system of all non- volatile user files.
Key Entry Delete All Files
:DELete:BINary
Supported N5182A with Option 651/652/654
:MEMory:DELete:BINary
This command deletes all binary files.
Key Entry Delete All Binary Files
:DELete:LIST
Supported All Models
:MEMory:DELete:LIST
This command deletes all List files.
Key Entry Delete All List Files
:DELete:SEQ
Supported N5182A with Option 651/652/654
•
"NVWFM:IQ_Data"
IQ_Data the file name. The directory path is not needed. The path
"/USER/WAVEFORM/" is implied.
• #14Y9oL
Data block
# This character indicates the beginning of the data block
1 Number of digits in the byte count
4 Byte count
Y9oL 4 bytes of data