Agilent Technologies n5181a - AWGN Real-Time Subsystem-Option 403 ([:Source]:Radio:awgn:rt); Bwidth; Iq:modulation:atten; Iq:modulation:atten:auto

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 139
Component Test Digital Commands
AWGN Real-Time Subsystem–Option 403 ([:SOURce]:RADio:AWGN:RT)
AWGN Real-Time Subsystem–Option 403 ([:SOURce]:RADio:AWGN:RT)
:BWIDth
Supported N5182A with Option 403
[:SOURce]:RADio[1]:AWGN:RT:BWIDth <value>
[:SOURce]:RADio[1]:AWGN:RT:BWIDth?
This command adjusts the flat bandwidth of the real- time AWGN waveform.
The variable <value> is expressed in units of Hertz (Hz–MHz).
*RST +1.00000000E+006
Range 1–1.0E8
Key Entry Bandwidth
:IQ:MODulation:ATTen
Supported All with Option 403
[:SOURce]:RADio:AWGN:RT:IQ:MODulation:ATTen <value>
[:SOURce]:RADio:AWGN:RT:IQ:MODulation:ATTen?
This command attenuates the I/Q signals being modulated through the signal generator’s RF path.
The variable <value> is expressed in units of decibels (dB).
*RST Varies (box dependent)
Range 0−40
Key Entry Modulator Atten Manual Auto
:IQ:MODulation:ATTen:AUTO
Supported All with Option 403
[:SOURce]:RADio:AWGN:RT:IQ:MODulation:ATTen:AUTO ON|OFF|1|0
[:SOURce]:RADio:AWGN:RT:IQ:MODulation:ATTen:AUTO?
This command enables or disables the I/Q attenuation auto mode.
ON (1) This choice enables the attenuation auto mode which optimizes the modulator
attenuation for the current conditions.
OFF (0) This choice holds the attenuator at its current setting or at a selected value. Refer
to “:IQ:MODulation:ATTen” on page 139 for setting the attenuation value.
*RST 1
Key Entry Modulator Atten Manual Auto