Agilent Technologies n5181a - 8656 B, 8657 A;B;D;J Programming Codes; Programming Codes

236 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
SCPI Compatibility
8656B, 8657A/B/D/J Programming Codes
8656B, 8657A/B/D/J Programming Codes
Programming Codes
NOTE Compatibility is provided for GPIB only; USB and LAN are not supported.
When using the programming codes in this section, you must set the remote programming language to
the correct language format.
• On the front- panel, press the following keys:
Utility > I/O Config > GPIB Setup > Remote Language > 8656B, 8657A/B
or
•Execute the SCPI command :SYSTem:LANGuage found on page 168.
To keep the remote language choice so that it does not reset with either preset, instrument power
cycle, or *RST, perform the following.
• On the front- panel, press the following keys:
Utility > Power On/Preset > Preset Language > 8656B, 8657A/B
or
•Execute the SCPI command :PRESet:LANGuage found on page 168.
To set the *IDN? response to match the remote language setting, use the command :SYSTem:IDN
located in “Changing the Signal Generator Identification String” on page 167.