Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 45
Basic Function Commands
List/Sweep Subsystem ([:SOURce])
:LIST:MANual
Supported All Models
[:SOURce]:LIST:MANual <value>|UP|DOWN
[:SOURce]:LIST:MANual?
This command sets a list or step sweep point as the current sweep point controlling the frequency
and power output.
If list or step mode is controlling frequency or power, or both, then the indexed point in the
respective list(s) will be used.
Entering a value with this command will have no effect, unless MANual is the selected mode. Refer
to “:LIST:MODE” on page 45 for setting the proper mode.
If the point selected is beyond the length of the longest enabled list, then the point will be set to the
maximum possible point, and an error will be generated.
Range List Sweep: 1–1601 Step Sweep: 2- 65535
Key Entry Manual Point
:LIST:MODE
Supported All Models
[:SOURce]:LIST:MODE AUTO|MANual
[:SOURce]:LIST:MODE?
This command sets the operating mode for the current list or step sweep.
AUTO This choice enables the selected sweep type to perform a sweep of all points.
MANual This choice enables you to select a single sweep point. The selected point controls
the frequency and/or amplitude according to the sweep type. Refer to
“:LIST:MANual” on page 45 for selecting a sweep point.
*RST AUTO
Key Entry Manual Mode Off On
:LIST:POWer
Supported All Models
[:SOURce]:LIST:POWer <value>{,<value>}
[:SOURce]:LIST:POWer?
This command sets the amplitude for the current list sweep points.
The maximum number of list sweep points is 1,601.
Range Refer to “[:LEVel][:IMMediate][:AMPLitude]” on page 57 for output power ranges.
Remarks The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
To Next Page
Loading...
