200 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:AM:INTernal:FREQuency:STEP[:INCRemen
t] <num>
[:SOURce]:AM:INTernal:FREQuency:STEP[:INCRemen
t]?
✓
[:SOURce]:AM:MODE DEEP ✓ Command accepted without error but does
nothing.
[:SOURce]:AM:MODE NORMal
[:SOURce]:AM:MODE?
✓
[:SOURce]:AM:WIDeband:STATe OFF|0
[:SOURce]:AM:WIDeband:STATe?
✓
[:SOURce]:AM[1]|2:EXTernal[1]|2:COUPling AC|DC
[:SOURce]:AM[1]|2:EXTernal[1]|2:COUPling?
✓
[:SOURce]:AM[1]|2:EXTernal[1]|2:IMPedance
<50|600>
[:SOURce]:AM[1]|2:EXTernal[1]|2:IMPedance?
✓ Command accepted without error but does
nothing.
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTern
ate <value><unit>
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTern
ate?
–
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTern
ate:AMPLitude:PERCent <value><unit>
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTern
ate:AMPLitude:PERCent?
–
[:SOURce]:AM[1]|2:INTernal[1]|2:FUNCtion:SHAPe
SINE
[:SOURce]:AM[1]|2:INTernal[1]|2:FUNCtion:SHAPe
?
✓ Supported but the following parameters are
not supported:
“TRIangle”|”SQUare”|”RAMP”|”NOISe”|
”DUALsine”|“SWEPtsine”
[:SOURce]:AM[1]|2:INTernal[1]|2:FUNCtion:NOISe
GAUSsian|UNIForm
[:SOURce]:AM[1]|2:INTernal[1]|2:FUNCtion:NOISe
?
–
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks
To Next Page
Loading...
