Agilent Technologies n5181a - Page 229

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 213
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:PULM:INTernal[1]:PERiod
<period>|MAXimum|MINimum|UP|DOWN
[:SOURce]:PULM:INTernal[1]:PERiod?
✓
[:SOURce]:PULM:INTernal[1]:PERiod:STEP[:INCRem
ent] <step>|UP|DOWN
[:SOURce]:PULM:INTernal[1]:PERiod:STEP[:INCRem
ent]?
✓
[:SOURce]:PULM:INTernal[1]:PWIDth <width>
[:SOURce]:PULM:INTernal[1]:PWIDth?
✓
[:SOURce]:PULM:INTernal[1]:PWIDth:STEP
<step>|DEFault|MAXimum|MINimum
[:SOURce]:PULM:INTernal[1]:PWIDth:STEP?
✓
[:SOURce]:PULM:SOURce INT|EXT[1]|EXT2
[:SOURce]:PULM:SOURce?
✓ Supported but the following parameters are
not supported: |SCALar|
Also, the Agilent MXG accepts the EXT2
parameter but only has a single external
output and selects EXT on the signal
generator if EXT2 is used.
[:SOURce]:PULM:SOURce:INTernal
SQUare|FRUN|TRIGgered|DOUBlet|GATEd
[:SOURce]:PULM:SOURce:INTernal?
✓
[:SOURce]:PULM:STATe ON|OFF|1|0
[:SOURce]:PULM:STATe?
✓
Digital Function Commands
All Modulation Subsystem
[:SOURce]:RADio[1]:ALL:OFF ✓
AWGN ARB Sub sy stem
[:SOURce]:RADio[1]:AWGN... – This subsystem is not supported.
AWGN Real Time Subsystem
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks