Agilent Technologies n5181a - Page 240

224 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:RADio[1]:ARB:TRIGger[:SOURce]:EXTern
al:SLOPe POSitive|NEGative
[:SOURce]:RADio[1]:ARB:TRIGger[:SOURce]:EXTern
al:SLOPe?
✓
[:SOURce]:RADio[1]:ARB:TRIGger[:SOURce]:EXTern
al[:SOURce] EPT1|EPT2|EPTRIGGER1|EPTRIGGER2
[:SOURce]:RADio[1]:ARB:TRIGger[:SOURce]:EXTern
al[:SOURce]?
✓
[:SOURce]:RADio[1]:ARB:VCO:CLOCk:RATE? –
[:SOURce]:RADio[1]:ARB:VCO:CLOCk[:SOURce]
INTernal|EXTernal
[:SOURce]:RADio[1]:ARB:VCO:CLOCk[:SOURce]?
✓
[:SOURce]:RADio[1]:ARB:WAVeform
"WFM1:filename"|"SEQ:filename"
[:SOURce]:RADio[1]:ARB:WAVeform?
✓
[:SOURce]:RADio[1]:ARB:WAVeform:NHEaders
"WFM1:filename"|"SEQ:filename"
[:SOURce]:RADio[1]:ARB:WAVeform:NHEaders?
✓
[:SOURce]:RADio[1]:ARB[:STATe] ON|OFF|1|0
[:SOURce]:RADio[1]:ARB[:STATe]?
✓
Edge Subsystem
[:SOURce]:RADio[1]:EDGE:... – This subsystem is not supported.
GSM Subsystem
[:SOURce]:RADio[1]:GSM:... – This subsystem is not supported.
Input Subsystem
:INPut:BERT[:BASeband]:... – This subsystem is not supported.
Measure Subsystem
:MEASure:[SCALar]:BERT:BTS:LOOPback:EDGE:MCS5[
:SENSitivity]?
– This subsystem is not supported.
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks