Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 229
SCPI Compatibility
8648A/B/C/D Compatible Commands
[:SOURce]:AM:INTernal2:FREQuency
<value><units>
[:SOURce]:AM:INTernal2:FREQuency?
–
[:SOURce]:AM:INTernal2:FUNCtion:SHAPe
SINe|TRIangle|SQUare|SAW
[:SOURce]:AM:INTernal2:FUNCtion:SHAPe?
–
[:SOURce]:AM:STATe ON|OFF
[:SOURce]:AM:STATe?
✓
[:SOURce]:AM:SOURce INTernal[l] ✓ Supported but the following parameters are
not supported: INTernal2
[:SOURce]:AM:SOURce INTernal|EXTernal
[:SOURce]:AM:SOURce?
✓
[:SOURce]:AM:INTernal:FREQuency 1kHz
[:SOURce]:AM:INTernal:FREQuency 400Hz
[:SOURce]:AM:INTernal:FREQuency?
✓
[:SOURce]:AM:EXTernal:COUPling AC|DC
[:SOURce]:AM:EXTernal:COUPling?
✓
Frequency Modulation Subsystem
[:SOURce]:CALibration:DCFM ✓
[:SOURce]:FM:DEViation <value>kHz
[:SOURce]:FM:DEViation?
✓
[:SOURce]:FM:STATe ON|OFF
[:SOURce]:FM:STATe?
✓
[:SOURce]:FM:SOURce INTernal[1] ✓ Supported but the following parameters are
not supported: |2|
[:SOURce]:FM:SOURce INTernal|EXTernal
[:SOURce]:FM:SOURce?
✓
[:SOURce]:FM:INTernal:FREQuency 1kHz
[:SOURce]:FM:INTernal:FREQuency 400Hz
[:SOURce]:FM:INTernal:FREQuency?
✓
Table 6-3 8648A/B/C/D Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
E44xxB
Remarks
To Next Page
Loading...
